Driving Test Practice

Washington: Speed and space — Part 2 Practice Test

Questions in this part include: “How does the guide define a hazard?” · “Why should you leave enough space in front of your vehicle?”

Independent educational site · not affiliated with any government agency or DMV

Start the test

Ready? Test yourself

18 questions · About 7 min

Answer to start, or tap Start below:

How does the guide define a hazard?

  • Instant feedback with an explanation
  • Every answer cites its source in the manual
  • Your best score is saved on this device
  • Keyboard: press 1 to 4 to answer and Enter for the next question

Questions are original and based on the official manual "Washington Driver Guide" (© 2025), Washington State Department of Licensing (DOL).

All 18 questions in this practice test

Take the test above first, then use this list to study. Tap “Show answer” to see the correct answer and explanation.

Show the questions and answersHide the questions
  1. How does the guide define a hazard?

    • Anything that requires you to make a change
    • Only a danger that is moving toward your vehicle
    • Any situation in which another driver breaks a traffic law
    • A road condition that forces you to stop completely
    Show answer

    Correct answer: Anything that requires you to make a change

    A hazard is anything that requires you to change something about your driving, such as speed or direction.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-1)

  2. A hazard on the road can be which of the following?

    • Moving only
    • Stationary only
    • Stationary or moving
    • Another vehicle only
    Show answer

    Correct answer: Stationary or moving

    A hazard is not limited to moving things; it can be stationary or moving, and it can be serious or minor.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-2)

  3. What is your responsibility when there is more than one hazard at the same time?

    • Come to a stop until only one hazard is left
    • Determine which hazard requires the most urgent response
    • Respond first to whichever hazard is closest to your vehicle
    • Wait for other drivers to decide which hazard comes first
    Show answer

    Correct answer: Determine which hazard requires the most urgent response

    With several hazards present, the driver must work out which one needs the most urgent response.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-3)

  4. What should you do when you approach a hazard so that you have more time to make safe decisions?

    • Drive faster to get past it
    • Keep your speed exactly the same
    • Move to the far edge of the road
    • Drive slower
    Show answer

    Correct answer: Drive slower

    Slowing down gives you more time and space to decide safely when a hazard is ahead.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-4)

  5. What does the guide say hazard perception is?

    • The ability to avoid every risk on the road
    • The ability to remember where hazards were on a road you have driven before
    • The ability to scan for potential risks and identify them before they become a problem
    • The ability to steer around a hazard once it is directly in your path
    Show answer

    Correct answer: The ability to scan for potential risks and identify them before they become a problem

    Hazard perception means spotting potential risks early, before they turn into problems.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-5)

  6. Which of these does hazard perception require?

    • Quick decision-making
    • Driving only on familiar roads
    • Using the horn to warn others
    • Knowing the speed limit of every road
    Show answer

    Correct answer: Quick decision-making

    Hazard perception requires attentiveness, quick decision-making and the ability to react appropriately to changing situations.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-6)

  7. What does the guide say risk awareness is?

    • Your ability to remove all risk from driving
    • Your knowledge of the penalties for common traffic violations
    • Your skill at controlling the vehicle if it starts to skid on a wet road
    • Your ability to identify present and potential hazards on the road
    Show answer

    Correct answer: Your ability to identify present and potential hazards on the road

    Risk awareness is spotting hazards that are present or might develop, so you can change your behavior to avoid a crash.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 154 · Open this page in the manual (Manual page 154)

    Report a problem with this question (wa-c5-7)

  8. How does the guide say you can stay aware of what is happening in front of you, beside you, and behind you?

    • By asking your passengers to watch for you
    • By using your peripheral vision and mirrors
    • By checking your mirrors only when you stop
    • By watching only the vehicle directly ahead
    Show answer

    Correct answer: By using your peripheral vision and mirrors

    The guide says to keep your head scanning continually, using peripheral vision and mirrors.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 154 · Open this page in the manual (Manual page 154)

    Report a problem with this question (wa-c5-8)

  9. After you spot a hazard that requires you to make a change, what should you do?

    • Check behind you for anything that affects your decision
    • Sound your horn to warn drivers behind you
    • Brake right away and keep your eyes on the hazard only
    • Turn on your hazard lights and keep going at the same speed
    Show answer

    Correct answer: Check behind you for anything that affects your decision

    What is happening behind you can affect your decision, so you check there after spotting the hazard.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-9)

  10. Why should you leave enough space in front of your vehicle?

    • To leave room for other drivers to pass you
    • To stay out of the blind zones of other vehicles
    • To see what is happening on the road ahead
    • To keep from needing to use your signals
    Show answer

    Correct answer: To see what is happening on the road ahead

    Enough space in front lets you see what is happening on the road ahead.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 155 · Open this page in the manual (Manual page 155)

    Report a problem with this question (wa-c5-10)

  11. What does the guide say situational awareness is?

    • Knowing the traffic laws and road conditions of every area you drive in
    • Planning your whole route and your stops before you start the engine
    • Watching only the vehicles that are closest to you on the road
    • Observing what is happening all around you and predicting what to prepare for next
    Show answer

    Correct answer: Observing what is happening all around you and predicting what to prepare for next

    Situational awareness is watching everything around you and predicting what to prepare for next, and you should do it constantly.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-12)

  12. Who could be the most affected by your decisions while driving?

    • The drivers coming toward you
    • Pedestrians on the sidewalk
    • The drivers behind you
    • The passengers in your vehicle
    Show answer

    Correct answer: The drivers behind you

    You need to know who might be affected by your actions, and the drivers behind you could be the most affected.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-13)

  13. In the guide's hazard management routine, what do you do in the Plan step?

    • Scan around you, check your rearview mirror, and decide if the change is safe
    • Let others know what you plan to do by using your signals and your horn
    • Make the change smoothly and try not to surprise anyone
    • Think about how it went and decide how to adjust your routine
    Show answer

    Correct answer: Scan around you, check your rearview mirror, and decide if the change is safe

    The Plan step is about scanning your surroundings, including behind you, and deciding whether the change is safe.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-14)

  14. In the guide's hazard management routine, what do you do in the Communicate step?

    • Check your mirrors and look over your shoulder for pedestrians
    • Decide whether the change is safe
    • Brake firmly to claim the space you need
    • Use your signals so that everyone knows what you plan to do
    Show answer

    Correct answer: Use your signals so that everyone knows what you plan to do

    In the Communicate step you let others know what you plan to do, using your signals.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-15)

  15. In the guide's hazard management routine, what do you do in the Check step?

    • Sound your horn to let all nearby drivers know that you are there
    • Recheck mirrors and look over your shoulder for pedestrians and bicyclists
    • Come to a stop to see whether other drivers yield
    • Think about how the maneuver went
    Show answer

    Correct answer: Recheck mirrors and look over your shoulder for pedestrians and bicyclists

    In the Check step you prepare your position and speed and recheck mirrors and blind areas for pedestrians, bicyclists and other drivers.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-16)

  16. In the guide's hazard management routine, what do you do in the Execute step?

    • Make the change smoothly and be ready to change your plan if needed
    • Prepare your vehicle position and speed for the change
    • Scan your environment to see what is happening around you
    • Wait for other drivers to signal before you move
    Show answer

    Correct answer: Make the change smoothly and be ready to change your plan if needed

    Execute means carrying out the change smoothly without surprising anyone, while staying ready to change the plan.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-17)

  17. In the guide's hazard management routine, what do you do in the Evaluate step?

    • Make sure no other driver is trying to move into the same space
    • Use your signals to show your intentions
    • Think about how it went and see if you need to adjust your routine
    • Decide if the change you want to make is safe
    Show answer

    Correct answer: Think about how it went and see if you need to adjust your routine

    The Evaluate step is a look back at how the maneuver went, so you can adjust your routine next time.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-18)

  18. When you prepare your vehicle position and speed in the Check step, what should the space allow you to do?

    • Make your change without using your signals
    • Make your change with no more than medium braking
    • Make your change without checking your mirrors
    • Make your change at the speed limit
    Show answer

    Correct answer: Make your change with no more than medium braking

    The Check step prepares your position and speed so there is enough space for the change with no more than medium braking.

    Source: ⁨Washington Driver Guide (© 2025)⁩, page 156 · Open this page in the manual (Manual page 156)

    Report a problem with this question (wa-c5-19)