Driving Test Practice

Pennsylvania: Road signs — Part 1 Practice Test

Regulatory, warning, and guide signs and what to do when you see them. — Part 1

Independent educational site · not affiliated with any government agency or DMV

Start the test

Ready? Test yourself

19 questions · About 8 min

Answer to start, or tap Start below:

A DIVIDED HIGHWAY sign means the road you are on intersects with a divided highway, which consists of:

  • Instant feedback with an explanation
  • Every answer cites its source in the manual
  • Your best score is saved on this device
  • Keyboard: press 1 to 4 to answer and Enter for the next question

Questions are original and based on the official manual "Pennsylvania Driver's Manual" (Pub 95), Pennsylvania Department of Transportation (PennDOT), Bureau of Driver Licensing.

All 19 questions in this practice test

Take the test above first, then use this list to study. Tap “Show answer” to see the correct answer and explanation.

Show the questions and answersHide the questions
  1. What do regulatory signs tell drivers?

    Four signs on posts: white DO NOT PASS, a yellow diamond with a black cross, green CITY CENTER 3 MILES, and a blue square with a white H
    • General information about services and distances
    • Possible hazards or changes in roadway conditions ahead
    • What you must do, or must not do, according to the law
    • Only which lane to use for through traffic
    Show answer

    Correct answer: What you must do, or must not do, according to the law

    Regulatory signs tell you what you must do, or must not do, according to the law.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 10 · Open this page in the manual (Manual page 10)

    Report a problem with this question (pa-c2-35)

  2. At an intersection with a STOP sign, what must you do?

    A red STOP sign
    • Slow down enough to check for traffic, without a full stop
    • Stop only if another vehicle is approaching the intersection
    • Yield only if a pedestrian is visibly crossing
    • Stop completely, then check for pedestrians and cross traffic
    Show answer

    Correct answer: Stop completely, then check for pedestrians and cross traffic

    At a STOP sign you must stop completely, check for pedestrians and cross traffic, and clear the intersection before you go again; slowing down without a full stop is illegal.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 10 · Open this page in the manual (Manual page 10)

    Report a problem with this question (pa-c2-40)

  3. At a YIELD sign, when must you come to a complete stop?

    A red and white YIELD sign
    • Only when necessary to yield to traffic or pedestrians
    • Every time, even when no other traffic is approaching
    • Only at night, when other traffic is harder to see
    • Never — a YIELD sign never requires stopping
    Show answer

    Correct answer: Only when necessary to yield to traffic or pedestrians

    At a YIELD sign, you stop only when it is necessary; otherwise proceed when you can do so safely without interfering with normal traffic flow.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 10 · Open this page in the manual (Manual page 10)

    Report a problem with this question (pa-c2-45)

  4. Where is a DO NOT ENTER sign placed?

    A square white sign with a large red circle crossed by a wide horizontal white bar, with the words DO NOT above the bar and ENTER below it in white.
    • At the far end of a one-way street or ramp
    • Only at railroad crossings
    • Only in school zones
    • At the beginning of a one-way street or ramp
    Show answer

    Correct answer: At the beginning of a one-way street or ramp

    The DO NOT ENTER sign is put at the beginning of one-way streets and ramps to tell you not to drive onto that street or ramp in the direction you are heading.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-48)

  5. What is the purpose of a WRONG WAY sign?

    A red and white WRONG WAY sign
    • It alerts you if you accidentally turned onto a one-way street or ramp
    • It replaces the need for a DO NOT ENTER sign at the start of the street
    • It marks the end of a divided highway and the start of two-way traffic
    • It indicates a detour around a closed one-way street or ramp
    Show answer

    Correct answer: It alerts you if you accidentally turned onto a one-way street or ramp

    WRONG WAY signs are placed farther down the one-way street or ramp to catch your attention if you accidentally turn onto it.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-49)

  6. What does a ONE WAY sign indicate?

    A black horizontal rectangular sign with a large white arrow pointing left and the words ONE WAY in black inside the arrow.
    • Traffic may move in either direction on that street
    • Traffic may move only in the direction the sign points
    • The road ends ahead
    • Parking is allowed only in the direction indicated
    Show answer

    Correct answer: Traffic may move only in the direction the sign points

    The ONE WAY sign means traffic is allowed to move only in the direction the sign is pointing.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-50)

  7. A DIVIDED HIGHWAY sign means the road you are on intersects with a divided highway, which consists of:

    • A single two-way roadway with a center turn lane
    • A roadway with no marked centerline
    • Two one-way roadways separated by a median or guide rail
    • Three lanes with reversible traffic direction
    Show answer

    Correct answer: Two one-way roadways separated by a median or guide rail

    A divided highway is really two one-way roadways that are separated by a median or a guide rail.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-51)

  8. At the DIVIDED HIGHWAY intersection described in the manual, what turns are permitted at the first roadway you reach, and then at the second?

    A white DIVIDED HIGHWAY sign showing a road crossing two roadways separated by a median
    • Left only at the first roadway, then right only at the second
    • Right or left at both roadways
    • U-turns only at both roadways
    • Right only at the first roadway, then left only at the second
    Show answer

    Correct answer: Right only at the first roadway, then left only at the second

    At the first roadway of a divided highway you can only turn right, and at the second roadway you can only turn left.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-52)

  9. NO TRUCKS, NO BICYCLES and NO PEDESTRIAN CROSSING signs mean:

    No trucks allowed sign
    • Those operators or pedestrians may not use that roadway
    • Those operators must yield to all other traffic on the road
    • Those operators must reduce speed by half
    • Those signs apply only during rush hour
    Show answer

    Correct answer: Those operators or pedestrians may not use that roadway

    Operators of trucks, bicycles and pedestrians may not use roadways where these signs are posted.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-53)

  10. What does a NO U-TURN sign prohibit?

    A white square sign showing a red circle with a red diagonal slash over a black arrow that curves back on itself.
    • Right turns from any lane at that intersection
    • Making a complete turn to go in the opposite direction
    • Left turns from any lane at that intersection
    • Passing another vehicle going in the same direction
    Show answer

    Correct answer: Making a complete turn to go in the opposite direction

    A NO U-TURN sign prohibits making a complete turn to go in the opposite direction.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-54)

  11. What does a NO RIGHT TURN sign indicate at an intersection?

    A white square sign with a black right-turn arrow under a red circle and slash
    • Right turns are permitted only on red
    • U-turns are prohibited
    • Right turns are prohibited at that intersection
    • Right turns are permitted only for buses
    Show answer

    Correct answer: Right turns are prohibited at that intersection

    A NO RIGHT TURN sign indicates that right turns are prohibited at that intersection.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-55)

  12. What does a NO LEFT TURN sign indicate at an intersection?

    A white regulatory sign with a black left-turn arrow under a red circle and slash
    • Left turns are permitted only on green arrow
    • Left turns are permitted only during off-peak hours
    • U-turns are permitted instead
    • Left turns are prohibited at that intersection
    Show answer

    Correct answer: Left turns are prohibited at that intersection

    A NO LEFT TURN sign indicates that left turns are prohibited at that intersection.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-56)

  13. Where a NO PARKING sign is posted, what does it mean?

    A white sign with a black letter P under a red circle and slash
    • You may not park a vehicle at that location
    • You may park for up to 15 minutes
    • Parking is allowed only for permit holders
    • Parking is allowed only at night
    Show answer

    Correct answer: You may not park a vehicle at that location

    You may not park a vehicle at locations where a NO PARKING sign is posted.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-57)

  14. A DO NOT PASS sign is placed in areas where:

    A white regulatory sign with black lettering reading DO NOT PASS
    • pedestrians may not cross the roadway at any point
    • you may not pass any vehicles going in the same direction
    • you may not exceed the posted speed limit
    • bicycles may not use the roadway at any time
    Show answer

    Correct answer: you may not pass any vehicles going in the same direction

    A DO NOT PASS sign may be placed in areas where you may not pass any vehicles going in the same direction.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-58)

  15. The DO NOT PASS sign is often accompanied by which yellow pennant-shaped sign?

    A white regulatory sign with black lettering reading DO NOT PASS
    • SCHOOL ZONE AHEAD
    • DIVIDED HIGHWAY BEGINS
    • NO PASSING ZONE
    • YIELD AHEAD
    Show answer

    Correct answer: NO PASSING ZONE

    The DO NOT PASS sign is often accompanied by the yellow pennant-shaped NO PASSING ZONE sign.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-59)

  16. A lane use control sign showing an arrow pointing left, posted over the left lane at an intersection where the adjoining lane may turn left or go straight, means:

    Sign showing two lanes designated for left turns
    • traffic in the left lane may go straight or turn left
    • the left lane is closed ahead
    • traffic in the left lane must merge right before the intersection
    • traffic in the left lane must turn left
    Show answer

    Correct answer: traffic in the left lane must turn left

    This sign indicates that at the intersection ahead, traffic in the left lane must turn left, while traffic in the adjoining lane may turn left or continue straight.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-60)

  17. A CENTER LANE LEFT TURN ONLY sign marks a lane that is:

    A white sign reading CENTER LANE above two opposing left-turn arrows and the word ONLY
    • only for left-turning vehicles from either direction
    • open to through traffic only during rush hour
    • reserved for buses and emergency vehicles only
    • for U-turns only
    Show answer

    Correct answer: only for left-turning vehicles from either direction

    This sign indicates a lane reserved for the exclusive use of left-turning vehicles in either direction, and is not to be used for through traffic or passing.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 11 · Open this page in the manual (Manual page 11)

    Report a problem with this question (pa-c2-61)

  18. If you are in a lane controlled by a sign showing arrows pointing both left and right ("Turn to Left or Right"), what may you do?

    A white sign with a two-headed arrow pointing left and right
    • Only go straight through the intersection
    • Travel in either direction the arrows point
    • Only turn left
    • Only turn right
    Show answer

    Correct answer: Travel in either direction the arrows point

    If you are in a lane controlled by a sign showing arrows in two directions, you may travel in either direction the arrows point.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 12 · Open this page in the manual (Manual page 12)

    Report a problem with this question (pa-c2-62)

  19. If you are in a lane controlled by a sign with a turn arrow and the word "ONLY" (such as TURN RIGHT ONLY), what must you do at the intersection?

    A white lane-use sign with a black right-turn arrow above the word ONLY
    • You may go straight if no other lane is open
    • You may choose to go straight or turn
    • You must turn, even if you entered that lane in error
    • The sign is only a suggestion, not a requirement
    Show answer

    Correct answer: You must turn, even if you entered that lane in error

    In a lane controlled by a turn arrow and the word "ONLY," you must make the turn shown, even if you are in that lane in error.

    Source: ⁨Pennsylvania Driver's Manual (Pub 95)⁩, page 12 · Open this page in the manual (Manual page 12)

    Report a problem with this question (pa-c2-63)