West Virginia: Traffic signals Practice Test
Red, yellow and green lights and arrows, flashing signals, turns on red, lane use control signals and crosswalk signals.
Independent educational site · not affiliated with any government agency or DMV
Ready? Test yourself
Answer to start, or tap Start below:
When traffic control signals are not needed or are out of order and are placed in flashing operation, they are the same as what?
- Instant feedback with an explanation
- Every answer cites its source in the manual
- Your best score is saved on this device
- Keyboard: press 1 to 4 to answer and Enter for the next question
Questions are original and based on the official manual "West Virginia Driver's Licensing Handbook" (Revised July 2026), West Virginia Division of Motor Vehicles (DMV).
All 24 questions in this practice test
Take the test above first, then use this list to study. Tap “Show answer” to see the correct answer and explanation.
Show the questions and answersHide the questions
-
When stopping at a stop sign or traffic signal, which of these must you NOT do?
- Stop where you can see the rear wheels of the vehicle ahead
- Stop before your vehicle enters the intersection when there is no stop line
- Stop behind the marked stop line
- Stop over a marked stop line, pedestrian crosswalk, or sidewalk
Show answer
Correct answer: Stop over a marked stop line, pedestrian crosswalk, or sidewalk
You must not stop over a marked stop line, pedestrian crosswalk, sidewalk, or other marker.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 31 · Open this page in the manual (Manual page 31)
-
When stopping at a stop sign or traffic signal, where must you not stop the vehicle?
- Behind the marked stop line
- Before the pedestrian crosswalk
- In the intersection
- Behind another vehicle where you can see its rear wheels
Show answer
Correct answer: In the intersection
You must not stop the vehicle in the intersection.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 31 · Open this page in the manual (Manual page 31)
-
If there is no stop line or crosswalk, where should you stop?
- Before your vehicle enters the intersection
- Far enough into the intersection to see cross traffic
- At the far edge of the intersection
- Wherever the examiner points
Show answer
Correct answer: Before your vehicle enters the intersection
With no stop line or crosswalk, you stop before your vehicle enters the intersection.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 31 · Open this page in the manual (Manual page 31)
-
What may a driver facing a circular green signal do, unless signs or pavement markings prohibit it?
- Go straight through only, with no turns allowed
- Go straight or turn right only, never left
- Go straight through, turn right, or turn left
- Turn left only after stopping first
Show answer
Correct answer: Go straight through, turn right, or turn left
On a circular green you may go straight, turn right, or turn left unless other traffic control devices prohibit a movement.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
What may drivers facing a green arrow do?
- Enter the intersection and then go in any direction you choose
- Stop and wait for a circular green light before moving
- Enter only if no other vehicles are in the intersection
- Enter the intersection to make the movement shown by the arrow
Show answer
Correct answer: Enter the intersection to make the movement shown by the arrow
A green arrow lets you enter the intersection to make the movement the arrow shows.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
When a green arrow is shown in a left-turn signal, what does it usually mean?
- Opposing traffic is stopped
- Opposing traffic has the right-of-way
- The signal is about to turn red
- Left turns are prohibited
Show answer
Correct answer: Opposing traffic is stopped
A green left-turn arrow usually means that opposing traffic is stopped.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
What does a steady circular yellow light mean?
- The red light is ending and will change to green
- You must stop and wait for the light to turn green
- The green light is ending and will change to red
- You may turn left without yielding to anyone
Show answer
Correct answer: The green light is ending and will change to red
A steady yellow warns that the green is ending and the light will change to red.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
What does a yellow left-turn arrow mean?
- The red arrow is ending and will change to green
- The green arrow is ending and will change to red
- Opposing traffic is stopped for your turn
- You may turn left after you yield to traffic
Show answer
Correct answer: The green arrow is ending and will change to red
A yellow arrow means the green arrow is ending and will change to red.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
Traffic facing a steady circular red signal must stop unless doing what?
- Making a movement permitted by a flashing light
- Passing through before opposing traffic starts
- Making a movement shown on a crosswalk signal
- Making a movement permitted by a green arrow
Show answer
Correct answer: Making a movement permitted by a green arrow
Traffic facing a steady circular red must stop unless it is making a movement a green arrow permits.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
How long must a driver facing a steady circular red signal remain stopped?
- Until allowed to proceed by another indication
- Until the cross traffic has fully cleared the intersection
- Until another driver signals to go ahead
- For at least three seconds before moving
Show answer
Correct answer: Until allowed to proceed by another indication
The driver must stay stopped until another indication allows the driver to proceed.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
What must you do when facing a steady red arrow for a left turn?
- Stop completely and remain stopped as long as the signal is red
- Stop, then turn left after yielding to oncoming traffic
- Slow down and go straight through with caution
- Stop only if other vehicles are in the intersection
Show answer
Correct answer: Stop completely and remain stopped as long as the signal is red
A red arrow means come to a complete stop before the intersection, stop line, or crosswalk and stay stopped while it is red.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 39 · Open this page in the manual (Manual page 39)
-
What is the purpose of flashers installed at certain intersections?
- To warn of a railroad crossing ahead
- To show which lanes are open
- To supplement or replace STOP signs
- To tell pedestrians when to cross
Show answer
Correct answer: To supplement or replace STOP signs
Intersection flashers are installed to supplement or replace stop signs.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What may a driver facing a circular flashing yellow light do?
- Come to a complete stop and then proceed
- Proceed through the intersection with caution
- Stop and yield to all other traffic
- Proceed only if the cross street is flashing red
Show answer
Correct answer: Proceed through the intersection with caution
A circular flashing yellow means you may go through the intersection, but with caution.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What is a circular flashing red light the same as?
- A yield sign
- A flashing yellow light
- A steady red arrow
- A stop sign
Show answer
Correct answer: A stop sign
A circular flashing red is the same as a stop sign, so drivers must stop completely and yield to all other traffic and pedestrians.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
When traffic control signals are not needed or are out of order and are placed in flashing operation, they are the same as what?
- Intersection flashers
- Lane use control signals
- Crosswalk signals
- Railroad crossing signals
Show answer
Correct answer: Intersection flashers
Signals placed in flashing operation act the same as intersection flashers.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
When are lane use control signals used?
- When a lane is reserved for school buses at all times
- When a railroad crossing is blocked by an approaching train
- When the direction of a street or certain lane changes during the day
- When a street is closed for a parade
Show answer
Correct answer: When the direction of a street or certain lane changes during the day
Special lane use signals control traffic when the direction of a street or a lane changes during the day.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What does a green downward arrow signal over a lane mean?
- The lane is reserved for left turns only
- Traffic may use the lane under the arrow
- Traffic must slow down in the lane under the arrow
- The lane is about to be closed
Show answer
Correct answer: Traffic may use the lane under the arrow
A green downward arrow means traffic may use the lane under the arrow.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What does a yellow X signal over a lane mean?
- The lane has just opened to traffic moving in both directions
- Traffic may use the lane under the signal
- The lane is reserved for buses and car pools only
- The lane is about to be closed or its direction is about to reverse
Show answer
Correct answer: The lane is about to be closed or its direction is about to reverse
A yellow X warns that the lane is about to be closed or that its direction is about to reverse.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What should you do when you see a yellow X over your lane?
- Move out of the lane as soon as you can
- Stop and wait in the lane until it changes
- Speed up to pass through before it closes
- Make a left turn out of the lane
Show answer
Correct answer: Move out of the lane as soon as you can
A yellow X means the lane is about to close or reverse, so move out of it as soon as you can.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What does a red X signal over a lane mean?
- The lane is about to be closed or to reverse direction
- The lane is reserved for left turns from either direction
- The lane is closed or being used by opposing traffic
- Traffic may use the lane under the signal
Show answer
Correct answer: The lane is closed or being used by opposing traffic
A red X means the lane is closed or being used by opposing traffic, so you must not use it.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
Crosswalk signals are traffic signals for whom?
- Bicyclists
- Pedestrians
- Drivers turning right
- School bus drivers
Show answer
Correct answer: Pedestrians
Crosswalk signals are traffic signals for pedestrians, who are to obey them.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What does a crosswalk signal showing a hand symbol or DON’T WALK mean?
- Pedestrians may cross only if no cars are coming
- Drivers must stop for pedestrians
- Pedestrians should cross quickly
- Pedestrians are not to cross the crosswalk
Show answer
Correct answer: Pedestrians are not to cross the crosswalk
A hand symbol or DON’T WALK tells pedestrians not to cross the crosswalk.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
What does a crosswalk signal showing a walking man or WALK mean?
- Pedestrians are safe to cross inside the crosswalk lines
- Pedestrians must hurry across the street before it changes
- Pedestrians may cross anywhere along the block
- Drivers may turn right without yielding
Show answer
Correct answer: Pedestrians are safe to cross inside the crosswalk lines
A walking man or WALK means pedestrians are safe to cross the street inside the crosswalk lines.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 40 · Open this page in the manual (Manual page 40)
-
A police officer's directions differ from a traffic sign, signal or road marking. Which do you follow?
- The signal or sign, since it is permanent
- Whichever is safer in your own judgment
- Whichever the traffic ahead is following
- The police officer's directions
Show answer
Correct answer: The police officer's directions
The directions of a police officer overrule the message of any sign, signal or road marking.
Source: West Virginia Driver's Licensing Handbook (Revised July 2026), page 49 · Open this page in the manual (Manual page 49)