General Knowledge: Seeing and communicating — Part 2
Questions in this part include: “When should you cancel your turn signal during a turn?” · “When you are about to pass a bicyclist or pedestrian, what should you assume?”
Independent educational site · not affiliated with any government agency or DMV
Ready? Test yourself
Answer to start, or tap Start below:
When should you cancel your turn signal during a turn?
- Instant feedback with an explanation
- Every answer cites its source in the manual
- Your best score is saved on this device
- Keyboard: press 1 to 3 to answer and Enter for the next question
Questions are written in our own words from the CDL manual; they are not the real test's questions. With your state chosen, every answer gives its page in your state's CDL manual. Without a state, answers cite the CDL manual, national model as printed by New Jersey (July 2017).
All 18 questions in this practice test
Take the test above first, then use this list to study. Tap “Show answer” to see the correct answer and explanation.
Show the questions and answersHide the questions
-
When should you cancel your turn signal during a turn?
- As soon as you begin turning the wheel
- Once the turn has been completed
- About halfway through the turn
Show answer
Correct answer: Once the turn has been completed
You need both hands on the wheel while turning, so keep the signal on until the turn is complete and then cancel it.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
How should you change lanes so that a driver you did not see can react?
- Slowly and smoothly, after signaling
- Quickly, to cross before others notice
- With one sharp move once the signal is on
Show answer
Correct answer: Slowly and smoothly, after signaling
A slow, smooth lane change gives a driver you did not see time to honk or avoid you.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
How can you warn following drivers that you are about to slow down?
- Tap the brake pedal lightly a few times
- Press the brake pedal firmly all the way down
- Shift to neutral and let the vehicle roll along
Show answer
Correct answer: Tap the brake pedal lightly a few times
Light taps flash the brake lights and warn drivers behind you before you slow down.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
Why should you warn the drivers behind you about a hazard ahead when you drive a large vehicle?
- Large vehicles are required by law to warn drivers
- Their headlights do not reach as far as yours do
- The size of your vehicle can hide the hazard from them
Show answer
Correct answer: The size of your vehicle can hide the hazard from them
A large vehicle can block the view of drivers behind it, so flashing your brake lights tells them to slow down.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
How should you warn drivers behind you before a tight turn in a large vehicle?
- Brake early and slow down gradually
- Brake late but firmly
- Signal once and keep your speed
Show answer
Correct answer: Brake early and slow down gradually
Car drivers often do not know how slowly a large vehicle must turn, so brake early and slow gradually to warn them.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
You have to halt in the traffic lane to let off passengers or unload. How should you stop?
- Stop quickly so that others see you stopped
- Stop without warning since the stop is short
- Flash the brake lights and do not stop suddenly
Show answer
Correct answer: Flash the brake lights and do not stop suddenly
Warn following drivers with your brake lights and slow down smoothly, not abruptly, when you stop in the roadway.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
You must drive very slowly. What should you do about your emergency flashers?
- Never use them while the vehicle is moving
- Use them if it is legal, and check the laws of states where you drive
- Always use them, because the law is the same in every state
Show answer
Correct answer: Use them if it is legal, and check the laws of states where you drive
Flashers can warn drivers who are catching up to you, but flasher laws differ from state to state, so check them.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
What is the risk of signaling another driver that it is safe to pass you?
- You could lose your license right away
- You could cause a crash and be blamed for it
- Your insurance would be canceled automatically
Show answer
Correct answer: You could cause a crash and be blamed for it
Do not wave other drivers past. If a crash happens, you may be held responsible and pay thousands of dollars.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
When you are about to pass a bicyclist or pedestrian, what should you assume?
- That they will stay where they are
- That they do not see you
- That they can hear your engine
Show answer
Correct answer: That they do not see you
Assume they do not see you, because they could suddenly move in front of your vehicle.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
At night, you are about to pass a bicyclist and it is legal to signal. How can you let them know you are there?
- Blink the headlights from low beam up to high and back
- Leave the high beams on the whole time you pass
- Switch on the four-way emergency flashers
Show answer
Correct answer: Blink the headlights from low beam up to high and back
Tap the horn lightly, or at night blink the headlights from low to high beam and back, to show others you are there.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
At dawn, dusk or in rain, which lights should you turn on to be seen?
- Headlights on low beam
- Headlights on high beam
- Only the clearance lights
Show answer
Correct answer: Headlights on low beam
Use the headlights on low beam. Clearance lights alone are not enough, and high beams can bother people even in the daytime.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
You pull off the road and stop, especially at night. What should you turn on?
- Only the taillights, set bright
- The four-way flashers
- The high beam headlights
Show answer
Correct answer: The four-way flashers
Turn on the four-way flashers. Taillights alone may make other drivers think you are still moving normally.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
When you have to stop on a road or its shoulder, how soon must warning devices be out?
- Within five minutes
- Within ten minutes
- Within thirty minutes
Show answer
Correct answer: Within ten minutes
Emergency warning devices must be put out within ten minutes of stopping on a road or shoulder.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
You stop on a divided highway. Where do you place your three warning devices?
- At 10, 50 and 100 feet toward the approaching traffic
- At 10, 100 and 200 feet toward the approaching traffic
- At 100, 200 and 300 feet behind the vehicle only on the shoulder
Show answer
Correct answer: At 10, 100 and 200 feet toward the approaching traffic
On a one-way or divided highway, place them 10, 100 and 200 feet back toward the approaching traffic.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
You stop on a two-lane road with traffic in both directions. Where do you place the warning devices?
- One each at 200 feet and 500 feet behind the vehicle
- All three set within 10 feet of the rear corners
- Within 10 feet of a corner, and 100 feet behind and ahead
Show answer
Correct answer: Within 10 feet of a corner, and 100 feet behind and ahead
On a two-way road, put one within 10 feet of a front or rear corner and the others 100 feet back and 100 feet ahead.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
A hill or curve keeps other drivers from seeing your stopped vehicle from 500 feet away. What should you do with the rear-most triangle?
- Set it back down the road where it gives warning
- Keep it at 100 feet so it stays near the vehicle
- Set it right beside the rear corner of the vehicle
Show answer
Correct answer: Set it back down the road where it gives warning
When the view is blocked, the rear triangle must be moved farther back so drivers get warning in time.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
How should you carry the warning triangles when walking out to place them?
- Behind your back, away from traffic
- Between yourself and the oncoming traffic
- Under your arm, with the front facing you
Show answer
Correct answer: Between yourself and the oncoming traffic
Holding the triangles between you and oncoming traffic makes you easier for other drivers to see.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
Why should you use your horn only when needed?
- It can drain the battery too quickly
- It can startle others and be dangerous
- It makes the vehicle much harder to see
Show answer
Correct answer: It can startle others and be dangerous
The horn can let others know you are there, but it can startle people and create danger when used without need.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)
-
Only in Arizona's manual
You stop your truck at the side of the road, especially after dark. Which lights should you be sure to switch on?
- The high beam headlights
- The cab interior lights
- The four-way flashers
Show answer
Correct answer: The four-way flashers
After pulling off and stopping beside the road, switch on the four-way emergency flashers, above all at night.
Source: CDL manual, national model as printed by New Jersey, Sections 1 to 3 (July 2017)