Driving Test Practice
English

Your stateNot chosenChoose it to see the page numbers of your state's own CDL manual.

Combination Vehicles: Exam simulator

40 random questions from every topic of this test, like a mini exam.

Independent educational site · not affiliated with any government agency or DMV

Start the test

Ready? Test yourself

40 questions · About 16 min

40 questions in this practice test; pass mark 80%, as on the real test.

  • Instant feedback with an explanation
  • Every answer cites its source in the manual
  • Your best score is saved on this device
  • Keyboard: press 1 to 3 to answer and Enter for the next question

Questions are written in our own words from the CDL manual; they are not the real test's questions. With your state chosen, every answer gives its page in your state's CDL manual. Without a state, answers cite the CDL manual, national model as printed by New Jersey (July 2017).

Sample questions

The exam simulator picks 40 random questions from every topic each time you start. Here are a few examples.

Show the questions and answersHide the questions
  1. What share of truck driver crash deaths comes from rollovers?

    • Less than a quarter
    • About one tenth
    • More than half
    Show answer

    Correct answer: More than half

    Rollovers cause over half of the crash deaths of truck drivers, which is why preventing them matters so much.

    Source: ⁨CDL manual, national model as printed by New Jersey, Section 6 (July 2017)⁩

    Report a problem with this question (cdl-cv-s6-001)

  2. For what purpose is the trailer hand valve meant to be used?

    Inside a tractor cab: a short lever with a black knob on the dash to the right of the steering wheel, beside a label reading TRAILER BRAKE.
    • Slowing the rig on a long downgrade
    • Testing the trailer brakes
    • Straightening out a trailer skid
    Show answer

    Correct answer: Testing the trailer brakes

    The hand valve is a testing tool. During normal driving the foot brake is the control to use.

    Source: ⁨CDL manual, national model as printed by New Jersey, Section 6 (July 2017)⁩

    Report a problem with this question (cdl-cv-s6-045)

  3. The general coupling steps differ a little from one rig to another. What should a driver do about that?

    • Use the general steps alone, since they fit every rig
    • Learn the coupling details of the trucks he or she will operate
    • Learn only the uncoupling steps, since coupling is the same on all rigs
    Show answer

    Correct answer: Learn the coupling details of the trucks he or she will operate

    Rigs differ, so the general steps are only a base. A driver must learn the exact coupling and uncoupling details of the trucks he or she drives.

    Source: ⁨CDL manual, national model as printed by New Jersey, Section 6 (July 2017)⁩

    Report a problem with this question (cdl-cv-s6-096)

  4. How much gap should you see between the upper and lower fifth wheel when you inspect a coupled rig?

    • No gap at all
    • A small gap, about the width of a hand
    • A gap just big enough to slip a flashlight in
    Show answer

    Correct answer: No gap at all

    The upper and lower fifth wheel must sit tight together with nothing visible between them.

    Source: ⁨CDL manual, national model as printed by New Jersey, Section 6 (July 2017)⁩

    Report a problem with this question (cdl-cv-s6-200)