Driving Test Practice
English

Your stateNot chosenChoose it to see the page numbers of your state's own CDL manual.

Combination Vehicles: Cheat Sheet

The facts of this test you most need, grouped by topic, each with its page in the manual. Print it or keep it on your phone.

Independent educational site · not affiliated with any government agency or DMV

Driving Test Practiceofficialdrivingtest.com

100% free — no email, no paywall. Print it, save it, or share it with anyone studying for the same test.

Driving combination vehicles safely

  • Stacking cargo higher lifts the center of gravity away from the road. A truck with a high center of gravity rolls over more easily.
  • Compared with an empty one, a loaded rig is ten times as prone to rolling in a crash.
  • A centered, spread-out load keeps the trailer from leaning, which lowers the risk of a rollover.
  • Rearward amplification is the cause of the whip-like swing of a trailer. The greater it is, the more easily the rear trailer overturns.
  • Allow one second for every 10 feet of vehicle length. Above 40 mph, add one more second.
  • An empty combination needs more distance to stop than a loaded one.
  • Leave the rig and move clear of the tracks, then phone 911 or another emergency number.
  • Letting off the brakes lets the wheels grip again, after which the trailer follows the tractor and straightens out.
  • Off-tracking, also called cheating, is the way the rear wheels take a different path from the front wheels around a corner.
  • Backing a trailer reverses the usual steering: you turn the wheel opposite to the direction you want the trailer to go.
  • Backing toward the driver's side lets you see where the trailer is going.

Combination vehicle air brakes and ABS

  • The foot brake feeds air to all brakes at once, so a skid or jackknife is much less likely than with the hand valve alone.
  • Parking brakes are what hold a parked vehicle. Add wheel chocks if the trailer has no spring brakes.
  • Each connection between units, such as tractor to trailer, carries a service line and an emergency line.
  • Relay valves let the trailer brakes come on sooner than they would without them.
  • Pressure loss in the emergency line applies the trailer emergency brakes. A torn hose or a trailer breaking loose can cause it.
  • Red marks the emergency line and blue marks the service line, which helps prevent mix-ups.
  • Glad hands are the couplers that join the tractor air-lines to the trailer air-lines.
  • Crossed lines leave the trailer without brakes, so you could drive away and find you cannot brake it. Always test the trailer brakes first.
  • Dummy couplers cover the hose ends so water and dirt cannot get into the couplers and air-lines.
  • Every shut-off valve is open except the one on the very last trailer, so air stays in the system instead of escaping at the rear.
  • Converter dollies, and trailers built before 1975, may lack spring brakes.
  • ABS is no excuse to follow closer, drive faster or drive with less care.

Coupling and uncoupling

  • Rubbing between the tractor and the trailer on a dry plate can make the rig hard to steer, so the plate must be greased as required.
  • A fifth wheel ready for coupling is tilted down toward the rear of the tractor.
  • The trailer must not move while you couple, so its wheels are chocked or its spring brakes are on.
  • Backing in at an angle can shove the trailer sideways and break its landing gear, so put the tractor directly in front of it.
  • The trailer should sit low enough that the tractor raises it slightly when backing under. Raise or lower the trailer to get that.
  • The emergency line goes to the trailer emergency glad hand, and the service line goes to the service glad hand.
  • Pulling the air supply knob out (or moving the valve control to emergency) locks the trailer brakes before the tractor backs under.
  • Use the lowest reverse gear so the tractor moves slowly under the trailer.
  • A gentle forward pull against the locked trailer brakes shows whether the coupling holds.
  • Keeping the key prevents anyone else from moving the truck while you are beneath the trailer.
  • Stopping with the frame under the trailer catches the trailer if the landing gear sinks or collapses.

Inspecting a combination vehicle

  • The upper and lower fifth wheel must sit tight together with nothing visible between them.
  • The jaws must close around the shank of the kingpin, not its head.
  • Air-lines must be properly connected, free of leaks, secured, and left with enough slack for turns.
  • A fifth wheel set too far forward can let the tractor frame strike the landing gear or the cab strike the trailer when turning.
  • Landing gear must be fully up, with no parts missing and nothing bent or damaged.
  • Doubles and triples get the same brake check as any other combination vehicle.