Your stateNot chosenChoose it to see the page numbers of your state's own CDL manual.
Doubles and Triples: Cheat Sheet
The facts of this test you most need, grouped by topic, each with its page in the manual. Print it or keep it on your phone.
Independent educational site · not affiliated with any government agency or DMV
Driving Test Practiceofficialdrivingtest.com
Pulling double and triple trailers
- Gentle steering and low speed on corners, ramps and curves help keep the trailers upright.
- The last trailer in the combination is the one most likely to turn over, so steer gently.
- Because the rig cannot stop suddenly, you must keep a bigger gap behind the vehicle ahead.
- The drive axles pull a longer rig with more dead axles than other drivers have, so traction is lost more easily on slick roads or hills.
- Pick a spot you can drive straight out of, and know how the lot is laid out, so you never face a long and difficult escape.
- Antilock brakes are required on dollies manufactured from March 1, 1998 onward.
- A dolly with antilock brakes has a yellow lamp on its left side.
Coupling and uncoupling doubles and triples
- Charging the trailer tank through the emergency line and then removing the line sets the trailer emergency brakes, provided the slack adjusters are set right.
- When you cannot trust the trailer's brakes, wheel chocks keep it from rolling.
- Put the heavier load up front and the lighter trailer at the rear for better stability on the road.
- A dolly has one or two axles and its own fifth wheel, so a semitrailer can be hooked behind a tractor-trailer to make a double bottom.
- Draining air through the dolly tank petcock frees its brakes. A dolly with spring brakes has a parking brake control instead.
- The trailer must sit slightly lower than the fifth wheel center, so the dolly raises it a little as it is pushed under.
- The plates must sit tight together with the jaws shut on the kingpin; a gap means a bad hookup.
- Without air at the rear, the trailer brakes cannot operate, and the problem must be found before driving.
- Before uncoupling, the rig must stand straight on ground that is firm and level, so nothing shifts or sinks while the trailers are separated.
- There are too many kinds of combinations for one method, so you learn the correct way from the manufacturer or the owner's specifications.
Inspecting doubles and triples and checking their air brakes
- The locking jaws must close around the shank of the kingpin, not its head.
- With the fifth wheel too far forward, the tractor frame can hit the landing gear or the cab can hit the trailer when turning.
- Air must pass through every front trailer to reach the trailers behind it, so those valves stay open.
- The last trailer's valves are closed so air does not escape from the end of the rig's brake lines.
- An open drain valve would let air leak out of the dolly tank, so it must be shut.
- The control normally pops out somewhere between 20 and 45 psi, within the range the manufacturer sets.
- Without a working valve, a leak in a hose or trailer brake can empty the tractor's air, applying the emergency brakes and risking loss of control.
- With the supply control out, a gentle pull on the trailer should show the emergency brakes are holding it.